Adtech Part No.	Supplied ID mm	Shrunk ID mm
ARC23	30	23
ARC27	35	27
ARC32	43	32
ARC40	49	40
ARC46	59	46
ARC56	67	56
ARC65	83	65
ARC80	98	80
ARC100	115	95
ARC125	149	113
ARC150	170	140
ARC175	187	166
ARC200	213	180
ARC225	239	200
ARC250	264	225
ARC300	315	275
ARC350	350	315

Adtech FEP Roll Covers eliminate sticky build-up problems with rollers used in hot or cold applications. The sleeve can be applied to metal or rubber rollers using a simple hot air gun. Down time to machine can be just minutes compared with days sending rollers away for sprayed non-stick coating. Thickness of FEP is normally 0.5mm compared with 0.005mm of a spayed on PTFE coating, and the cost is about the same or even less.

Adtech FEP roll covers are available for self application from 6mm diameter to 250mm diameter or we will fit covers to rollers of any size in our works or at your premises. The inside surface can be supplied etched if the sleeve needs to be bonded to the roller (e.g. under nip conditions)

We can also supply PFA roll covers for extra high temperature applications e.g. laminating paper to polyethylene.

We strongly advise that you contact our engineers for advice on the best size for your application.
Roll covers are always held in stock in the sizes listed. In addition we have many other sizes both smaller and larger than listed that are also either in stock or can be produced on short delivery time.
Unusual sizes, with different wall thicknesses can be manufactured to order

For very hot (190 to 250 degree C) applications we can supply PFA instead of FEP. e.g. laminating paper to polyethylene.

If roll covers are to be bonded to the roller then the inside surface needs an etching treatment to make it bondable. This work is normally done to order on covers held in stock.

See here for instructions for fitting Adtech roll covers

 

Standard sizes are normally available from stock, and we are also able to custom manufacture virtually any size for special applications in single quantities.

For sizes below 25mm see our FEP heat-shrink sleeve range