Adtech FEP Roll Covers eliminate sticky build-up problems with rollers used in hot or cold applications. The sleeve can be applied to metal or rubber rollers using simple hot air gun. Down time to machine can be just minutes compared with days sending rollers away for sprayed non-stick coating. Thickness of FEP is normally 0.5mm compared with 0.005mm of a spayed on PTFE coating, and the cost is about the same or even less.
Adtech FEP roll covers are available for self application from 6mm diameter to 250mm diameter or we will fit covers to rollers of any size in our works or at your premises
Inside surface can be supplied etched if the sleeve needs to be bonded to the roller (e.g. under nip conditions)
We can also supply PFA roll covers for extra high temperature applications e.g. laminating paper to polyethylene.
The following sizes are standard and normally available from stock, we are also able to custom manufacture virtually any size for special applications
| Adtech
Product Number |
ID as
Supplied mm inches |
ID After
Shrinking mm inches |
| ARC23 ARC27 ARC32 ARC40 ARC46 ARC56 ARC65 ARC80 ARC100 ARC125 ARC150 ARC175 ARC200 ARC225 ARC250 ARC300 ARC350 |
30
1.18 35 1.37 43 1.69 49 1.92 59 2.32 67 2.63 83 3.26 98 3.85 115 4.52 149 5.86 177 6.96 187 7.36 213 8.38 239 9.40 264 10.39 315 12.40 350 13.77 |
23
0.9 27 1.06 32 1.26 40 1.57 46 1.81 56 2.20 65 2.55 80 3.14 95 3.74 113 4.44 113 4.44
|
We strongly advise that you contact our engineers
for advice on the best size for your application.
Roll covers are always held in stock in the sizes listed. In addition we have
many other sizes both smaller and larger than listed that are also either in
stock or can be produced on short delivery time.
Unusual sizes, with different wall thicknesses can be manufactured to order
For very hot applications we can
supply PFA instead of FEP
If roll covers are to be bonded to the roller then the inside surface needs an
etching treatment to make it bondable. This work is normally done to order on
covers in stock.